EACE Journal — Vol. 9, No. 9
THE USE OF NATURAL POZZOLLAN TO STABILIZE CINDER GRAVEL FOR A ROAD BASE (ALONG MODJO-ZTWAY ROUTE)
Thomas Teshome and Samuel Tadesse
Abstract
In road construction using locally available materials plays a significant role in cost and time saving of road construction projects Cinder gravel isabundantly a vai/ab/e in different parts of Ethiopia. However, its use has been for too limited purposes due to its light weight rough surfaces and high porosity. In this study two types of Natural Pozzolanas were collected from Aivay Area in order to stabilize cinder gravel for a road base One wasPumice (coarser) and the other was volcanic ash (Pumicite) Pozzollanicity test was conducted on both samples using strength activity index test.For the Pumice the strength activity index valuewas 8917% while for the volcanic ash (Pumicite) itwas 7643%. Since the volcanic ash (Pumicite) satisfies the minimum requirement for pozzolaniciy and is finer, it was used as a stabilizer. Fromthe unconfined compression test conducted ontwo specimens of the volcanic ash (Pumicite), the average UCS value increases from 8465 kPa to 266.63kPa for 3 and 7 curing days, respectively. The cinder grave/ was blended with 0, 4, 8, 12, 16,20, and 24% by mass of volcanic ash (Pumicite). Compaction, California Bearing Ratio, Gradation,Atterberg limit Los Angeles Abrasion, Aggregate Crushing Value, Ten Percent Fines Value, Absorp-fron and Specific gravity tests were conducted inthe laboratory.From the laboratory test results of moisture content vs. density relationship, it has been observed that the optimum amount of natura/ pozzo//ana (volcanic ash) is 20% by mass proportion at a density of 1.76g/cc. For the optimum blending proportion; the range of soaked CBR increases from 98% to 245% whereas for the unsoaked condition the CBR increases from 118% to 307%, for O to 28 days curing.
Read Full Article (PDF)